| Our
"speciality of the house." Machined finishes
are available at virtually the same cost of plasma cutting.
Our rings and discs are machined to a tolerance of +1/16"
- .000" on the O.D. and +.000" - 1/16"
on the I.D. to give you a smoother edge with better
concentricity than a plasma cut edge. In addition, you
have no heat affected zone, which increases your tool
life. We can turn up to 100" diameter, and face
the surface of one or both sides to any special thickness
or RMS finish. All of this means a lower ultimate "cost
in use" to you.
With over 100 pieces of cutting equipment, nearly any
machined configuration is readily available. We can
provide bevels, grooves or fine surface and edge finishes
that you need. Be sure to review our capabilities for
milling, drilling, tapping and counterboring that are
described in more detail on other pages in the Value
Added Plate Processing section of our web site.
|
|
|
